Leak detection in Bedford

Leak detection in Bedford and Kempston

Charlie arrives with a thermal camera, a ground microphone and tracer gas, and pinpoints the leak before a single tile is lifted.

No find, no fee

A Bedford slot in 24 to 48 hours

Insurer ready report included

Nothing dug up to find it

Get a quote

Tell us what you have noticed and where. We ring you back to talk it through. No find, no fee.

No find, no fee

24/7 enquiries

Non-invasive methods

Reports for insurance claims

Bedford has two kinds of pipework problem. The Victorian terraces around Castle Road and Queens Park have old supply pipes and heating added later, usually run under suspended timber floors. The post war estates at Brickhill, Goldington and Putnoe have solid floors with heating pipes set into the screed.

Water tracks along a joist or under a slab and surfaces as a damp skirting two rooms away, or never surfaces and simply turns the meter. That is why underground leak detection Bedford wide starts with the reading, not the wet patch. Underfloor heating leak detection Bedford customers ask about works the same way, through an intact floor.

Water meter chamber at the boundary of a Bedfordshire house Leak detection engineer using a thermal imaging camera inside a Bedfordshire home

How a Bedford visit runs

1

Work out which system it is

A meter test with every tap closed separates a supply pipe leak from a heating leak. A pressure test on the boiler circuit then confirms the heating side. No floor is touched at this stage.

2

Narrow it to the room

The thermal camera maps every pipe run through the floor or wall and shows where the temperature is wrong. On a Bedford terrace that usually means one bay under the boards, not the whole house.

3

Mark it and write it up

Acoustic listening or tracer gas brings it down to a hand span. Charlie marks the floor, photographs the spot and writes the whole thing up for you.

Equipment on the van for Bedford

Thermal imaging

An infrared camera sees the heat a leaking hot pipe leaves in a floor and the cold a wet patch leaves in a wall. Carpet, laminate and plaster stay where they are.

Acoustic listening

Water forced through a split in a pressurised pipe hums. A ground microphone picks that hum up through concrete, tarmac and soil, and the loudest reading sits over the break.

Tracer gas

The circuit is drained and filled with a safe hydrogen based tracer gas. It leaves through the leak, rises through screed or boards, and a hand probe reads where it comes out.

Recent leak detection jobs around Bedford

A Victorian terrace in Queens Park had a meter that crept with every tap off. The supply pipe ran under the tiled front path, and the ground microphone found the leak at a joint just inside the gate, where the old pipe had been extended in copper. On the Brickhill side a 1960s house was losing heating pressure into a solid floor; the thermal camera showed a warm patch under the dining room and tracer gas confirmed a pinhole in the pipe to the radiator. In a converted house near the town centre, water appearing in the ground floor flat was traced by testing each flat's pipework in turn to a shared riser rather than the tenant's own bathroom.

Nearby places we cover

Kempston is joined on to Bedford and gets the same visit. Biggleswade sits off the A1 and Flitwick down the A6, both an easy add to a Bedford day. Leak detection Bedfordshire wide runs out of the same van, so Houghton Regis is covered too.

How the report feeds a trace and access claim

Most buildings policies carry trace and access cover, which pays for finding the leak and the opening up needed to reach it. Our report gives the insurer the tests run, the readings, the thermal images and a marked photograph of the leak position. You send it with the claim.

Questions people ask

We book by area where we can, so a Bedford job often sits alongside a Kempston or Luton call, usually within 24 to 48 hours. Enquiries are taken at any hour.

Not to locate it. The camera and the microphone work through the boards, and tracer gas comes up between them. We mark the one or two boards that need to come up for the repair.

Yes. The loop is isolated and pressure tested first to prove it is the floor and not a radiator feed. Thermal imaging then shows the loop pattern and the break in it, and tracer gas confirms the point.

Usually, yes. In a converted house or a block, we test each flat's supply and heating separately and work out whether the water comes from your pipework, a neighbour's or a shared riser. The report says which.

You pay nothing, because water leak detection Bedford visits are no find, no fee. If every test comes back clean, the problem is something other than a leak, such as a failed seal or condensation, and we say so.

Get a leak found in Bedford

Ring 07897 020 680, day or night, and we will tell you the next slot for Bedford.

Landline 01440 840 772. Email hello@completeleakdetection.co.uk.